Converts your Magsafe Charger into a dedicated charging station. Ideal for desks and bedside tables.
This print requires double sided tape. See Amazon link below for adhesive which doesn't leave residue. Folded over duct tape will work just fine if damaging the underlying surface is not a concern.
Fits only the official Apple Magsafe charger.
Print Recommendations
Print Material: PLA
Infill Percent: 15%
Layer Height: .15 (Larger layer heights work just fine if you are ok with more visible layers)
Perimeters: 2
Supports: NONE
Print orientation: Place the dock with the base against the build plate (see Prusa Slicer file for reference.)
Double Sided Tape Required
Amazon Link to 3M .4 inch double sided tape https://a.co/d/3n44GFr
This adhesive twists off easily and doesn't leave residue. See base photo for recommended amount and placement.