A passthrough flipper with each entrance flowing to a unique exit. Also includes Flip-Flop logic. Watch the video to see it in action.

Hardware / Printing

• One M3x14 screw (or longer)
• One M2x12 screw
• One M3 washer
• PLA, 2 walls, 10% infill, no supports

Assembly Insert an M3x10 screw into the flipper, stack a washer on the screw, then install the flipper. Crank it down until it stops rotating freely. Slowly back out the screw 1/8th of a turn. Repeat until the flipper freely rotates.

This tile is part of my Mechanical Flippers Pack. Check the others out.

• 180 https://than.gs/m/1116280
• Alternator https://than.gs/m/1116292
• Bounce Flop https://than.gs/m/1327656
• Follower https://than.gs/m/1228246
• I-Flop https://than.gs/m/1288093
• JL Flop https://than.gs/m/1327657
• Omni-Flip https://than.gs/m/1228247
• Side Flop https://than.gs/m/1116295
• T-Switch https://than.gs/m/1116307
• Trident https://than.gs/m/1228248
• Tri-Switch https://than.gs/m/1288137
• XC Flop https://than.gs/m/1327667