A turnstile-like double dispenser. Watch the video to see it in action.

Hardware / Printing

• One M3x12 screw (or longer)
• One M3 washer
• PLA, 2 walls, 10% infill, no supports

Assembly

1. Install an M2x12 screw into the base for rotation lock.
2. Insert an M3x12 screw into the flipper, stack a washer on the screw, then install the flipper. Crank it down until it stops rotating freely.
3. Slowly back out the main screw 1/8th of a turn. Repeat until the flipper freely rotates.

This tile is part of my Counterweight Dispensers Pack. Check the others out.

• 180zu https://than.gs/m/1327652
• AltWave https://than.gs/m/1031259
• Anchor https://than.gs/m/1288074
• K-zu https://than.gs/m/1288115
• Overdrive Wave https://than.gs/m/1031248
• Wave https://than.gs/m/1031247
• Sailboat https://than.gs/m/1288126
• Tsunami https://than.gs/m/1031250
• Twozu https://than.gs/m/975596