A 180 degree tile that has Sozu and Turnstile logic. Tested with both 10mm and 3/8in. Watch the video to see it in action.

Hardware / Printing

• One M3x10 screw (or longer)
• One M3 washer
• PLA, 2 walls, 10% infill
• Base prints with no supports.
• Flipper requires supports (Structure = Normal, Placement = Touching Bedplate, Overhang Angle = 50+)

House Rules Only visible balls in this count towards the 3-ball rule. It feels like it doesn’t need a rules card, but if people want it I can make one :)

Assembly 2. Place a 10mm or 3/8" ball inside the counterweight pocket. 3. Insert an M3x10 screw into the flipper, stack a washer on the screw, then install the flipper. Crank it down until it stops rotating freely. 4. Slowly back out the screw 1/8th of a turn. Repeat until a ball can rotate the flipper and exit.

This tile is part of my Counterweight Dispensers Pack. Check the others out.

• 180zu https://than.gs/m/1327652
• AltWave https://than.gs/m/1031259
• Anchor https://than.gs/m/1288074
• K-zu https://than.gs/m/1288115
• Overdrive Wave https://than.gs/m/1031248
• Wave https://than.gs/m/1031247
• Sailboat https://than.gs/m/1288126
• Tsunami https://than.gs/m/1031250
• Twozu https://than.gs/m/975596