Awarded to:NerdyOreo

First Make published

Nov 15, 2021 · 3:52 AM

NerdyOreo

0

Followers

0

Following

0

Model Views

0

Downloads

0

Comments

0

Likes

Achievements

Novice Maker

First Make published

0

Followers

0

Following

0

Model Views

0

Downloads

0

Comments

0

Likes

Sort by:

Left Vent Mount - I used strategically placed zip ties to hold it on because I wasn't able to get any tapes to stick to the PETG. Printed with Prusament PETG on the Prusa Mini. 100% infill for rigidity. Took 2 hours and 30 minutes. No supports. 5mm brim to make sure it stuck to the build plate. Using a Scosche Magicmount Magnetic dash mount to hold the Accessport. Have yet to run the wire. I plan on running it through the vent that this clips too. I will be reprinting this using ASA to make sure it doesn't warp during the summer or while cranking the heat during the winter. - 3d model