tracking pixel
M

#CCTMothersDayRemix Holding Child 3D-Puzzle

by

MrSimonPaints

Follow
Follow
Remix Model
Like
M
MrSimonPaints
Image 1 of 6
#CCTMothersDayRemix Holding Child 3D-Puzzle 3d model
2D
3D
Makes
#CCTMothersDayRemix Holding Child 3D-Puzzle 3d model
#CCTMothersDayRemix Holding Child 3D-Puzzle - Puzzle pieces should fit nicely - 3d model
#CCTMothersDayRemix Holding Child 3D-Puzzle 3d model
#CCTMothersDayRemix Holding Child 3D-Puzzle 3d model
#CCTMothersDayRemix Holding Child 3D-Puzzle 3d model
#CCTMothersDayRemix Holding Child 3D-Puzzle 3d model
2 Likes11 DownloadsMay 18, 2021


So, I spent almost an entire week to make this printable. It is a fully functional 3d-Puzzle version of the Holding Child from the #CCTMothersDayRemix. It can all be printed in one go (“Assembled_Puzzle.stl”), thou you should be familiar on how to use support. The distance between the puzzle pieces is 0,12 mm so your layer Hight should be around that value. I would recommend printing it at a scale of 130 % so you can use a layer Hight of 0,16 mm. For stability of the puzzle-pieces print at a slightly higher temperature than usually and use a wall line count of 3 or 4. Quite conveniently there is enough space for a LED-tealight inside the model at a scale of >130% ;) If your print fails at a specific hight or one puzzle-piece breaks you can just print a small part of the model (Part1.stl, Part2.stl and Part3.stl) “Filled.stl” and “Connected.stl” are much easier to print but only have the look of a 3d-Puzzle and are not functional.

I also have Instagram, where I uplode some 3d-artsy-stuff (mr.simonpaints)


2 Likes11 DownloadsMay 18, 2021




2 Likes11 DownloadsMay 18, 2021