So basically while I was reassembling my RT101 I broke one of the clips that attaches to the wire making it usable but with a lot of rattle these stabs have a thicker clip which makes them stronger.

Printing this piece in resin is highly recommended (I would say its a must), I haven't tested it in a filament printer Please leave your suggestions in case that the design can be improved I would really appreciate it ^^.

7/10/2022 Added Stems for SI in case that you loose the stock ones 1.13 and 1.15mm refer to the thickness of the cross

1.15mm turned out to be a little tigher so I decidded to make a 1.13mm one