Side Quests [SQ1E2]

In this side quest I set out to make a 3D printable fidget slider toy that incorporates magnets.

| ! | MAKE SURE ALL OF THE MAGNETS IN ALL OF THE PIECES ARE POINTING THE SAME DIRECTION | ! |

To make the slider, print one Top piece, one Bottom piece, and as many Slider pieces as you want to stack between them, I personally like three sliders between the top and bottom.

The two versions, "Lock" and "No Lock" are labeled accordingly and will only fit together with the other pieces of their version. The Plate will stick flat-to-flat with any of the other flat faces of the other versions.

Side Quest Episode

Full Design Session

| Supplies | 600 Pack 5x2mm Neodymium Magnets

| 3D Print Info | Materials: HATCHBOX Mint Green PLA - Amazon Nozzle Diameter: 0.6mm - Amazon Layer Height: 0.15mm Temps: 210C Nozzle, 70C Build Plate Wall Count: 2 Infill: 100% Print Speed: 60 mm/s, 6 slower initial layers at 10 mm/s Build Plate Adhesion: 3 line skirt Printer: ELEGOO Neptune 3 Max - Amazon

My printer has a custom hotend, here's what I used to build it: | Custom Hotend Supplies | Hardened Steel Nozzle - Amazon Copperhead C-E Bimetallic Heat Break - Amazon High Temperature Plated Copper Heater Block - Amazon Heater Block Silicone Cover - Amazon High Temp Thermistor - Amazon Metric Bolt Assortment - Amazon

| Affiliate disclaimer | Any affiliate links do not increase the cost of the item to you at all, and simply provide a small commission to me for my recommendation, should you decide to make a purchase using the link. If you aren’t comfortable with this, that’s totally ok, feel free to buy them without using my links. That’s how much I value my recommendations, I still stand by them even if they don’t benefit me at all. I only recommend things that I use for myself on a daily basis.

Stay Moxious