The first version I created was very simple and minimalistic holding just the Immortal-T. It works but was a little fragile.

Later I saw the need for improvement. Something more robust and secure. I had also been playing with the idea of a rearview camera or third-person view and wanted a cam mount for the rear.

This is the start of the new improved version. Currently a work in progress. I considered the force and weight that would be pulling on the top plate and gave it 4 mounting points.

For added support, a section was added that uses the XT60 plug as a brace to help hold it in place.

A channel was cut through the middle on the bottom for the Immortal-T antenna wire.

If you find this model useful and would like to help support my FPV addiction so I can provide more models, [follow this link](https://www.paypal.com/paypalme/DeanNeitman) to make a donation of any amount.

QAV Pro 5 Whoop Tail  .stl

My first version I created was very simple and minimalistic holding just the Immortal-T. It works but was a little fragile.

Later I saw the need for improvement. Something more robust and secure. I had also been playing with the idea of a rearview camera or third-person view and wanted a cam mount for the rear.

This is the start of the new improved version. Currently a work in progress.

Created to protect the camera in the iFlight Titan DC5 frame. This adds protection to the camera without anything in view. 

Tested on DJI Air Unit and cam. A bad crash broke a previous lens. I added this and it has gone through several more crashes and seems to do the job.

Print in TPU. The infill amount is up to you. I used 70% to make it durable but you could definitely go with less.

iFlight Titan DC5 Camera Bumper.stl

I created these as a replacement for the original rubber feet on the Lumenier QAV-Pro 5" Whoop. I found that torquing down the screws tight just tore the holding ring or a good skid would do the same.

These have more material between frame and screw and wear nicely. You will need a longer m3 screw to reach the threads, however. Print in TPU. Infill density will determine the weight and how long they last before they wear out.

Lumenier QAV-Pro 5" Cinewhoop Foot.stl

Artist, musician, web designer, photographer, multimedia producer, 3D designer and FPV pilot.

Activity related to collaborating with others on models

Likes, comments, and activity from your community

A roundup of models that we think you'll like

For when we think someone might have posted your content as their own

New content from your premium memberships

Emails and messages from designers you follow

MoBlades

Achievements

Seedling

QAV Pro 5 Whoop Tail .stl

iFlight Titan DC5 Camera Bumper.stl

Lumenier QAV-Pro 5" Cinewhoop Foot.stl