Qidi X-Pro LCD Rear Cover

This is a rear cover to protect the exposed circuit board on the back of the LCD touch screen. The model is printable on the X-pro without supports or additional brim, etc. 

The photos show one printed in white for illustrative purposes, but you can print any color since the part is only visible if you're looking from inside the printer. 

The face is 1mm thick and the rim is 2mm thick, and is designed to sit on the molded bosses (not the board) and attach using self-tapping screws into the screw towers in the bezel.

I printed this with at 0.2mm layer height, 3 walls, 3 solid top/bottom layers and infill doesn't matter since these settings don't leave space for infill between solid walls/layers. 

Sidewinder X2 Z-Sync Belt Tensioner

This is a belt tensioner for the Z-sync belt on the Artillery Sidewinder X2. 

It attaches to the upper left frame using the stock screws and allows tightening of the sync belt without changing the geometry of the lead screws. 

Additional parts needed:
- M5 Bolt
- M5 Nut
- Idler pulley (5mm shaft)

BigTreeTech PI-TFT70 Enclosure

TFT70 Base

Voron 2 (350mm) TFT70 Mounts

Voron 2 TFT70 Bracket R

Voron Afterburner Noctua Fan Bracket

The Voron Afterburner hot end fan is a 4010 and fits snugly in the fan bracket but the Noctua fans are just slightly larger, causing the stock bracket to break at the thin wall where the pivot is located. I redesigned the bracket to accommodate the Noctua 4010 fan.

Voron Drag Chain Guide Rework

The Voron 2.4 rear drag chain guide is flat and tends to catch on each of the openings in the drag chain so I redesigned the part. 

Smart Controller Knob - Inverted

GT2 Belt Axis Locks

GT2 Belt Axis Lock

End Stop Board

Activity related to collaborating with others on models

Likes, comments, and activity from your community

New content from your premium memberships

Emails and messages from designers you follow

Get notified when someone purchases your models or memberships

MindRealm

Achievements

Seedling

Debutant