Vase Mode, No Supports, Quick Print Subscribe To the Mimetics 3D Commercial Tier on Thangs. for rights to sell prints

Check out the latest 3 table lamps here: Stria Table Lamp: https://than.gs/m/1049903 Trysta Table Lamp: https://than.gs/m/1049896 Hestra Table Lamp: https://than.gs/m/1049906

You cut a striking figure where the light and shadow meet. To observe from just one angle leaves the picture incomplete

The Trysta is for you

The Trysta (Tris-tuh) Table Lamp graces each room with modern elegance.

The clean, ribbed design complements a wide range of aesthetics, while the vertical pattern both hides and accentuates the curves that lie within.

What's holding you back? Rendezvous with destiny

Model Details: You can start printing this model right away on a Bambu printer using the prepared 3mf files optimized for printing this model.

This model is designed to fit this Pendant Light kit: https://www.amazon.com/dp/B0CHHVSLQ1

This model is for personal use only. If you're interested in selling physical prints of this model, please subscribe to the Mimetics 3D Commercial Tier on Thangs.

Assembly Instructions Refer to the video in the image carousel

For some fun pendant lights, check out: Faces of Death - Pendant Light, Vase Mode: https://than.gs/m/1046980 The Flustra - Vase Mode Pendant Light (Large): https://than.gs/m/1047316

Safety First Intended for use with 9 watt LED Lights
Other lights can get too hot and damage/deform the plastic

Print Settings: Vase Mode/Spiralize/Spiral Vase Mode for the Lamp Shade Regular printing for the Base and Cap 0.55 mm wall thickness 8 bottom shell layers Print with the circular cut-out on the build plate

100% Scale Attempting to scale this model up or down will prevent the opening from fitting the intended Pendant Light kit: https://www.amazon.com/dp/B0CHHVSLQ1

Please let me know if you would like to see other variations of this lamp.