Baby Basilisk (Long) - Articulated Snap-Flex Fidget

Print-In-Place, No Supports, Articulating Fidget Toy

Subscribe To the Mimetics 3D Commercial Tier on Thangs. for rights to sell prints of your cool new friend.

This baby basilisk just can't wait to be king of the serpents. Until then, he's content to lounge about and strike a pose for you and your friends.

This flexible, articulated fidget toy incorporates the unique Mimetics 3D Snap-Flex joint, allowing each body segment to wiggle freely OR snap into a fixed position to maximize your fidget experience.

This Baby Basilisk is the first in a line of Snap-Flex models by Mimetics 3D, and is available for free for a limited time.

Snap-Flex Collection: This articulated fidget toy integrates the Mimetics 3D "Snap-Flex" joint. This allows it to both move smoothly, mimicking the fluid motion of living creatures, AND stabilize in a firm pose, providing a premium fidgeting experience.

Each SNAP will resonate as a symphony of satisfaction to your ears, confirming your masterful manipulations.

Snap-Flex Instructions: To Lock: Push Body Segments together To Unlock: Pull Body Segments Apart

Other Models:

If you like this Baby Basilisk, be sure to check out the latest articulated model here: Tight Tolerance Cold Snap: https://than.gs/m/960229 Medium Tolerance Cold Snap: https://than.gs/m/960234 Loose Tolerance Cold Snap: https://than.gs/m/960235

Make sure to revisit us frequently for more thrilling Snap-Flex models to come. We're eager to hear your feedback and collaborate on refining this model going forward.

This model is for personal use only. If you're interested in selling physical prints of this model, please subscribe to the Mimetics 3D Commercial Tier on Thangs.

Print Settings: 0.2mm Layer Height 3 Wall Loops 3 Top Shell Layers Brim Suggested

Suggested Material: PLA or PLA+ Note: Silk PLA is too weak to hold up to repeated use of the Snap-Flex joint. Use silks at your own risk

No Supports, Print-In-Place at 100% scale Printing any smaller may disable the Snap-Flex joint.

Printing larger than 100% will make the snap louder AND harder to pop, so be sure to do a shorter test print to make sure it's not TOO hard to snap into place.

These tolerances are TIGHT and you'll likely have to snap each segment a few times before it's loose enough to snap/unsnap easily. I recommend you use regular PLA or PLA+. ABS might be even better, but I haven't tried it yet.

If you print this in resin, please let me know how it turns out. I imagine you would need a more flexible/less stiff resin for it to work appropriately.