A lot of people have been asking for an unsolvable maze and here it is. This maze has no solution, the maze pattern is a closed loop that has no end.
If you like the design, don’t forget to like the design page and if you printed it, don't be shy - add a make to show off your creation!
If you want to hear about upcoming designs, have a little sneak peaks and be a part of a maze, puzzle and other brain teaser lover community, make sure to join Mazetropolis Facebook community . There will be a giveaway once we reach 100 members in the group. Be among the first ones and get the most out of it!
It is important to follow the instructions of assembly process:
- take the "half-circle" connector pipes and push them into the smaller part of the case (they are both the same)
- Once the connector pieces are pushed in the small case part as far as they go, take the small case part and slide it on the maze as far as it goes.
- On the small case part there are holes, arrange them to face any path on the maze and use hook pieces and push them in all the way while the hook goes into the path of the maze.
- Once that's done, take the larger case part and make sure to arrange it correctly - make sure that the "TowerMaze ->" alligns with the end of the arrow on the small case part.
- Once you have made sure that the case is arranged correctly, push the case parts together - congratulations, you have assembled the Impossible maze and it is ready to prank your friends!
This design takes around 4 hours and 40 minutes to print and uses around 48 meters of material (Based on Bambu Lab's P1S default settings.
Important: Change wall type to Arachne and do not use supports