Everyone has their own fight and these hands crawling through the wall symbolize the strength that it requires to break through those difficulties and get to the other side. This design consists of two parts - hands that are printed with supports enabled and base part that does not require any supports. The hand part has rectangular holes in the bottom that perfectly stick on to the base without requiring any glue to stick them together. Additionally this model includes a small printed marker that can be used to mark the screw hole place on the wall for easier use.
Print specifications:
Hands:
Supports: yes (I used auto tree supports with “on build plate only” enabled) Brim: NO Print Dimensions: Height = 1.7 cm (0.67 Inches) | Base = 9.4 cm x 4 cm (3.7 Inches x 1.58 Inches) Layer height: 0.2 mm Infill type: Gyroid Infill percentage: 12% Print speed: 250 mm/s Print time: 54 Minutes Amount of material required: ~ 4.8 m
Base:
Supports: NO Brim: NO Print Dimensions: Height = 1.1 cm (3.03 Inches) | Base = 15 cm x 18 cm (5.91 Inches x 7.09 Inches) Layer height: 0.2 mm Infill type: Gyroid Infill percentage: 12% Print speed: 250 mm/s Print time: 2 hours and 33 Minutes Amount of material required: ~ 30.5 m
Hole marker:
Supports: NO Brim: NO Print Dimensions: Height = 0.2 cm (0.08 Inches) | Base = 5.5 cm x 2.5 cm (2.17 Inches x 0.99 Inches) Layer height: 0.2 mm Infill type: Gyroid Infill percentage: 12% Print speed: 250 mm/s Print time: 10 Minutes Amount of material required: ~0.8 m
TOTAL PRINT TIME: 3 Hours and 37 Minutes TOTAL PRINT MATERIAL: ~ 36.1 m