Snap Shut Deck Box - Basic Version
This is the Snap Shut Deck Box, Basic version. It holds either 100 cards double sleeved or 60 cards plus the Accessory Box inside. Use the Accessory box to carry all of your dice, coins, and tokens that you would need for your game of choice. This box is perfect for any of your favourite TCGs like Pokemon, Magic the Gathering, One Piece, YuGiOh, Digimon, Dragon Ball, or whatever else you may want to use it for!
This whole set can be printed without supports if your bridging is good, otherwise a little support on the lid may be needed where the clips slide in. Make sure to print the clips on their side so you get the most strength out of them and then just slide them into the bottom piece.
Go check out the other versions available including the Window version to show off your favourite card or Leader/Commander or the Stylized versions too!
Snap Shut Deck Box - Basic Version
076. Golem - Basic & Ornamental
Window Espeon
Window Umbreon
644. Zekrom - Basic & Ornamental
491. Darkrai - Basic & Ornamental
Window Mewtwo
Window Mew
Window Psyduck
Window Gengar - Pokemon
Window Snorlax
Window Eevee
Window Jigglypuff
Lugia Bust
309. Electrike - Basic & Ornamental
235. Smeargle - Basic & Ornamental
Lugia Diorama
Flareon Bust
Tyrunt Skull - Solid & Hollow
Flareon Diorama
Bambu Studio is complaining about "non-manifold edges", can you fix the STL?
This box is awesome, holds a deck and a bunch of D6 dice and whatnot. One issue though - the lid seems reversible, but the snaps are 2mm (one internal lip width) to one side, so it isn't :(
how did you get the snaps in? Mine got stuck and then while trying to get them out I broke them in half. Now I need to restart the print
They should just slide right in. It will be snug so they dont fall out but not too tight that they wont go in. Make sure you dont have any artifacts on the clips that would cause them from going in smoothly as well.
Just to piggyback off that, my snaps are too loose, to the point where they can slide out with the top if the box is tipped the wrong way. I'm guessing a bit of super glue should address that?
any chance of a 60 card version? (for the one piece themed version specifically)