When I originally came up with the concept of a renter friendly wall planter, I immediately started getting requests for a mount that could accommodate both command strips AND screws. Seems simple (the final solution was) but it was tricky to figure out how to do this while hiding the screw holes. Finally figured it out though!
SUPER IMPORTANT! 👇 All it took was adding an extra insert to fill the command strip void behind the screw holes. Without this, the screw will bust through the back of the planter.
The 4.5" mount now has an extra spot for a third command strip, adding a ton of strength.
The 2.75" mount is now a circle and has spots for two command strips. The screw insert is not needed for the 2.75" mount.
Supports None needed!
Scaling I wouldn't recommend scaling this one since it perfectly fits the command strips and the screw holes are designed specifically for #10-12 x 1-1/4 in anchors and screws.
Orientation All mounts should have the sliding dovetail facing up.
Print Settings .2mm layer height 15% gyroid infill 2 walls
Hardware Hardware:
- Command Medium Picture Hanging Strips
- #10-12 x 1-1/4 in anchors and screws
Filament and non 3D printed items for this model can be found on my Amazon Storefront, linked here: https://bento.me/loftedgoods