I've been wanting to make some vases with handles for a while. The handles are surprisingly strong. You may notice a little funkiness on them but it's not super noticeable in person. I've also included a version without the handles.
Supports Tree supports are needed for the handles. Make sure you check "On build plate only" in your support settings. Otherwise it will place supports inside the pot which I found unnecessary.
Scaling Can be scaled up or down however you like!
Orientation The vase should print upright with the bottom on the build plate.
Print Settings .2mm layer height 15% grid infill 2 walls
Filament & Hardware Filament: Bambu Lab Mandiran Orange Matte PLA
Filament and non 3D printed items for this model can be found on my Amazon Storefront, linked here: https://bento.me/loftedgoods