A rectangular wall planter that features a hidden drip tray underneath. Water your plants while they're on the wall or remove the inner pot and water in the sink. Then put the inner pot back in the wall pot and let the drip tray catch any residual water (this is what I do).

How to mount to your wall

1. Insert the keyhole marker into the keyhole slots
2. Firmly press against wall in desired location and the keyhole markers will make an indent where you need to drill
3. Drill holes using a 3/16" drill bit
4. Insert wall anchors and screws (#8 - #10 x 1" screws and anchors)
5. Make sure the screw head is sticking out just far enough to tightly fit in the keyholes. If it's too loose, tighten the screw incrementally until it's a tight fit.
6. Attach planter to the wall

Supports None needed!

Scaling I wouldn't recommend scaling since the keyhole slots perfectly fit the #8 - #10 x 1" screws and anchors.

Orientation

• Everything prints upright with its bottom on the build plate

Print Settings

• .2mm layer height
• 15% gyroid infill
• 2 walls
• Set bridge flow to 1.6 for drip tray

Filament

Bambu Lab Matte PLA

Colors I used:

• Latte Brown
• Ivory White

Hardware

• #8 - #10 x 1" screws and anchors

Filament and non 3D printed items for this model can be found on my Amazon Storefront, linked here: https://linktr.ee/loftedgoods