Model originally uploaded to Thingiverse at https://www.thingiverse.com/thing:5553683.

Edit: I am an idiot lololol, not sure why my brain completely skipped over the fact that the tip of the hat needs supports anyways so I might as well have left the original design with the overhang since supports were going to be on anyways. Will look into fixing this soon

EDIT EDIT: Added the original one that I made thats going to need supports under the actual brim of the hat. Only the hats should need the supports the pumpkin should print fine without

Printed an original Hug Me Ghost with Witches hat, and then a Makies pumpkin. I noticed there was a remix for a hat for the Makies pumpkin but wasnt too enthralled with the hat design,however I loved the hat from the Hug Me Ghost Remix so I cut off the top of the pumpkin and put the witches hat over it in Tinkercad, originally tried to make it bigger but didn't like printing with supports for the overhanging hat so I resized it smaller so it can be printed without supports. Enjoy!

Please note this is my first remix of something, any questions comments or suggestions are all welcome