Cute little container with a Moo tag! printed in parts and put together, can be printed without AMS by switching out colors during printing 🐄🐄

Design contains Milk Carton ONLY, you can find the cows here - Cow Boops

⚙️Slicer Settings

• 100% cow fits in 100% carton

• 3 walls, 15% gyroid or 3D honeycomb infill, no supports required

• USE A BRIM for the top of the carton! I recommend inner and outer brim with 0.1 mm brim gap

• Tested down to 60% scale. If scaling down print the top of the carton with 0.16 layer height to avoid hanging layers.

Ive included a tolerance test for the top of the carton. A tolerance test is a quick check (3 grams) to make sure the tops of the carton will be a good fit with the bottom. + + ⭐As with all of my designs, I strongly advise that the printed models are not to be handled by children under 3 without proper supervision⭐

📌This model is for PERSONAL USE ONLY, to sell prints of these designs you will need to SUBSCRIBE TO THE MERCHANT PLAN available on my profile page - Click here📌