Ludo Popsicle Clicker

The Ludo Popsicle clicker is addictively fun. You only need to snip plastic standoffs if your clickers have them. This model will fold over electrical prongs as you press the clicker into place, so no need to snip those!

Assembly

1. Remove supports
2. Press the clicker into once half of the popsicle (the clicker goes down sideways)
3. Press the stick into to the clicker (add glue)
4. Glue the other side of the popsicle down onto the first side.
5. Wait a few minutes for Glue to dry before clicking.

Clicker This design will work with most 3 pin plate mounted keyboard switches. We Recommend..

• For Small Quantities Kailh Box White Clickers are the best.
• For Large Quantities: Pawpers, by Pawpular Prints : These also have pre-snipped prongs, making assembly easier!

Printing

Print at 0.2mm layer height. Use adaptive layers to get a smoother top surface. Add tree supports to the underside of the top of the fire hydrant.

Filaments I Used: Red: Bambu Matte Scarlet Red Tan: Bambu Matte Desert Tan