This design is for personal use only. If you would like to sell physical prints, please support my work by purchasing a commercial license through a Thangs membership. Your support is greatly appreciated!

⭐ Included: Watermelon Clicker with buttcheeks!

💙 Additional parts needed:

• This design requires a mechanical keyboard switch. Most MX switches can be used. I am using Gateron switches which can be purchased on amazon.

✨ Filament used: Bambu PLA Red Bambu PLA Green Bambu PLA White Bambu PLA Black

⚙️ Print Settings: Layer Height: 0.20 mm Wall Count: 2-3 walls Infill: 10%-15% Gyroid

🍫 Assembly: Remove the support from the top piece. Place the switch into the square hole in the top piece and push down. Place the bottom piece over the switch and push down firmly.