This design is for personal use only. If you would like to sell physical prints, please support my work by purchasing a commercial license through a membership. Your support is greatly appreciated!

⭐ Included: Dumpling clicker (All 3 faces included)

💙 Additional parts needed: This design requires a mechanical keyboard switch. Most MX switches can be used. I am using Gateron switches which can be purchased on amazon.

✨ Filament used: Bambu Yellow Bambu Black Bambu Pink Bambu Cyan Bambu Purple

⚙️ Print Settings: Layer Height: 0.16 mm Wall Count: 2-3 walls Infill: 10%-15% Gyroid

🍫 Assembly: Remove the support from the dumpling. Place the switch into the square hole in the basket and push down. Place the dumpling over the switch and push down firmly.