This design is for personal use only. If you would like to sell physical prints, please support my work by purchasing a commercial license through a Thangs membership. Your support is greatly appreciated!

⭐ Included: Brownie clicker (with and without keychain hole)

💙 Additional parts needed:

• This design requires a mechanical keyboard switch. Most MX switches can be used. I am using Gateron switches which can be purchased on amazon.
• Glue will be required to adhere the candy pieces to the top

✨ Filament used: Sunlu PLA Roasted Chestnut (bottom) Sunlu PLA Brown Bambu PLA Blue Bambu PLA yellow Bambu PLA Green Bambu PLA Pink

⚙️ Print Settings: Layer Height: 0.20 mm Wall Count: 2-3 walls Infill: 10%-15% Gyroid

🍫 Assembly: Remove the support from the top piece. Glue down the candies to the top piece. Place the switch into the square hole in the base and push down. Place the top piece over the switch and push down firmly.