I couldn't help but feel like there needed to exist a larger version of this for my monitor + PC power cables. I've reconstructed Kevin's V1 clip and made it 2.4x the size of the original for a ~12mm opening. It still printed in place beautifully and threads in just like the original. Cheers K2_Kevin, great work on this one. I've got a few of them and they all worked perfectly
Great design, I printed both versions without issue. It's the first cable clip I've printed for my giant Multiboard setup, and I like it enough that it might be the only one I bother to use. Both versions printed together used less than 8g of plastic, and finished in around an hour.
Just an added note, I'm using a reinforced "beefy" raised snap and these still thread in the same as intended. I didn't have to scale them up for a nice fit with PLA, but I might for ABS. My PLA seems to be a little more bloaty than my ABS, but that could just be my cheap filament.
The v2 worked great after scaling to 103%. It then fit snug upright in a medium weight bearing snap (printed using the same print profile at 100%), while having enough grip through the threads to sit at any angle needed.
For those having issues with this being stuck after printing: I'm wondering if nozzle size is a factor here. I haven't had any problems with these, but I'm running a 0.3mm nozzle. If possible, try with a smaller nozzle diameter.
Hello were can I finde the Remix of the bigger version?
I'd also like to print this remix. Maximum cable management!
Just an added note, I'm using a reinforced "beefy" raised snap and these still thread in the same as intended. I didn't have to scale them up for a nice fit with PLA, but I might for ABS. My PLA seems to be a little more bloaty than my ABS, but that could just be my cheap filament.
Rotating part works great but attaching to the snap is a bit loose. Will try and upscale 1% and see if it fits a snap then. Thanks for the share!
The v2 worked great after scaling to 103%. It then fit snug upright in a medium weight bearing snap (printed using the same print profile at 100%), while having enough grip through the threads to sit at any angle needed.
cannot get this to budge at all.
For those having issues with this being stuck after printing: I'm wondering if nozzle size is a factor here. I haven't had any problems with these, but I'm running a 0.3mm nozzle. If possible, try with a smaller nozzle diameter.
Not getting a functional rotation from this print in place design. Anyone else having trouble? Could you share a STEP file?
try ironing all top surfaces, that'll make it easier to snap. I had to use a tiny flathead screwdriver to wiggle a few before they popped