This model is restricted by licensing terms.
View license.
ModelA pocket pinball design based on old-timey pinball machines.
Requirements: x1 M3 machine screw preferably 20mm or longer x1 compression spring that can fit over the screw (some pen springs will fit) x1 M3 nut, preferably a lock-nut type 6mm diameter ball bearing or airsoft pellet. Smaller sizes (like a bb) should work too Optional: x1 extra return spring for the ball launcher x1 transparent glass or plastic shield so the ball doesn't pop out (10cm x 7cm)
Assembly:
- Insert M3 screw into hole at the bottom right corner
- Slide compression spring over M3 screw in the ball launch gutter
- Screw M3 nut onto the M3 screw
- Drop a ball into the gutter
- (Optional) Glue a transparent sheet of glass or plastic on top so the ball doesn't fly out.
- Enjoy!
Category:
3 Likes2 DownloadsOctober 3, 2023
3 Likes2 DownloadsOctober 3, 2023
This model is restricted by licensing terms.
View license.