Saw that LTT released a 3d model of a holder for their screwdriver to use with their MCM power bar. I have a Wall Control pegboard, figured i would remix to work with an off the shelf magnet. Didn't work, it would just slide down as soon as i put the screwdriver in it. Changed gears to make it mount to the standard pegboard holes. It fits a little loose but it does work. I'm not sure how to tune it to fit tight against the pegboard, but since this still does the trick I decided to publish it.

Printed with a 0.6 nozzle at .18 layer height. Supports enabled, type normal - snug Outer brim only enabled. At 15mm, brim helps keep the supports down.

Re-slice for your nozzle size, but keep use the modified settings.