I like to use mason jars around my workspace as pencil, paintbrush, or tool holders. but to get those off of my desk, I designed this clip to turn them into containers that I can hang on my SKÅDIS pegboard.

Printed from PLA or ABS, this flexes just enough to snap snugly around the ridge that is just below the jar threads (so that you can still screw on lids if you like)

Prints easily upside down, without support.

Versions:

• v3, was experiencing a lot of stringing when printing with ABS, so I filled in the sides with a supporting interface layer. 0.8mm thick so it doesn't increase print time much but greatly increases strength and print quality.
• v2, moved hooks up flush to top, so the model can print without supports, added bevels or chamfers everywhere possible to reduce overall volume, and minimize printer jerking