This model is restricted by licensing terms.
View license.
0 Likes1 DownloadsJuly 21, 2023
This model is restricted by licensing terms.
View license.
Model originally uploaded to Thingiverse at https://www.thingiverse.com/thing:6133572.
This is a ring that you insert into the top of a 33.2 oz baby formula container. This gives you a bar to scrap the scoop to get a level scoop without using your finger. This can remain in the top of the container with the lid on.
-- These are printed right side up without supports. Brim is optional.
v2.0 This is the basic ring without the added support in the following version.
v2.1 This is the same as previous version with the added lip to help keep the ring in place while scraping up on the scraper bar.
This could be used for smaller containers if x/y is resized to the correct mm. Leave the z axis at its original size.
0 Likes1 DownloadsJuly 21, 2023
This model is restricted by licensing terms.
View license.
0 Likes1 DownloadsJuly 21, 2023
This model is restricted by licensing terms.
View license.