Been working on this design for a little while now and I've finally finished. Very happy with the way it came out . Please review the tips below before printing.

Helpful Print Tips:

• Everything should snap together expect the wires, unfortunately I couldn't figure out a good way to snap them into place so you will need to glue them.
• Everything should fit together tight so it might require some force to get them into place. If you want to add glue you can but I didn't been too expect for the wires.
• I printed mine on a Bambu A1. For the center dome I added a modifier in Bambu Studios and positioned it over the "glass" part. I then reduced the infill density to 0.
• The center dome and the card body (where the bottom pins go) are the only spots that need supports.
• I did include a full model file (with all the parts together) just in case you want to print one piece.

Parts to Buy: This design works with the Bambu Lamp Kit. Here is the link: https://us.store.bambulab.com/products/led-lamp-kit-001?id=41806987395208

This model is for personal use only, if you want to sell physical prints of my designs, or you want to support me, please check my Subscription: https://thangs.com/designer/Noob3dPrinting