ThangsBambuContest Printed PLA Initial layer hot end temp 210 build plate 60 Normal print temp 200 hot bed 60 Print speed 75 Infill 75 Walls 3mm Support normal everywhere angle 86 triangles screw only scale X975% Y97.5% Z100% for looser thread. print rest at 100% see picture for print orietation. Build plate adhesion used brim you can use none if you have good adhesion makes deburring easer. Use 2 x countersunk rib head 10G x65mm TPI8 screws for strength in the clamp and screw. Use 3 x counter sunk black timber screws 4mm x 25mm for extra strength. Glue caps in Rubber pads 19dia self-adhesive. DO NOT OVER TIGHTEN OR USE Excessive FORCE on THE CALMP Do not leave in direct sunlight Do not use as a standing anchor point when stick is in the clamped position