This Bundle includes the:

- Dragon Mask
- Tiger Mask
- Ork Mask

All of these models **CANNOT** be used for commercial purposes and are Personal Use Only

A tiger mask cosplay/show piece for artists!

Printing tips

I'd recommend using low infill (5% or 10%) and at least 3 perimeters to keep it light.

Notes about the mask

In the final model there are holes for a hands free mask. It is also split into two if you want to have only the bottom half (Like I did), or you can have the full faced mask by attaching the two by melting or glues.

The painting shown in the photo was done with pastels and some spray painting

How I recommend painting it

Base coat the teeth black then mask it out with tape. Then base coat the rest with an orange spray paint (or whatever color you want). After you have all of the base coats done take some oil pastels and put whatever color scheme you want on it. blend them into each other well and REMEMBER TO SEAL IT so it doesn't smudge.

Tiger Mask

Bottom Tiger.stl

Ork Mask made for cosplay and display purposes. 
NON commercial use/Personal Use only

This mask takes no assembly other than the straps you can add to the holes so it can act like a mask.

Ork mask

Ork mask low poly.stl

A mask for dragon enthusiasts, artists looking for a new painting project, and cosplay outfits!

Assembly

 It is split up into two parts so that the teeth won't snap off. you can connect the two pieces ideally melting them together. It has built in strap holes to easily make it hands free.

Painting

PAINT THEM INDIVIDUALLY AND THEN PUT THEM TOGETHER FOR THE FINISHING TOUCHES!!

If you want to replicate how I painted it, I would recommend doing a base coat of your choice and then using oil pastels and blend them well. REMEMBER to SEAL IT so the pastels don't smudge!

3 Mask Bundle

Categories:

Tags:

Models in this collection

Tiger Mask

Ork mask

Dragon mask!