Spiderman hand INSPIRED web string art/ fan art
PLEASE READ CAREFULLY some strings may fail this is normal and do not panic. Walls must be set to archane depending on printer the strings from wall to center may print twice, this is normal . if the first string fails usually the second will be ok. if both strings complete then they will adhere to each other, either way you should end up with one string. The web completes one spiral, ive not known this to fail Print the strings at least a separate colour for best chance, even if you print the rest of the model the same colour. carefully trim any failed strings. either at the end or preferably pause the model at various points and trim as it prints. its just easier before too many strings print. The model photographed had no failed strings 0.4 nozzle. 0.2 layer height do not change the layer height as you will get errors. at least 15% infill otherwise the string won't have anything to latch on to, if you can maybe increase to 20%. Plate includes a twist fidget to purge into. The rear of the model is black. This saves hour and probably days on print time. Extending the pattern through the entire model could cause string fails with all the colour changes. Of course you can easily alter the colours or paint to your requirements in the slicer. Do not resize the model as you risk the strings not working please do not give a poor raating for bed adhesion issues, it is your responsability to ensure the bed is clean etc and use glue if your worries about adhesion.
- So for those that sell. I am placing the legalities of selling this model in your hands, i take no responsibility if you choose to sell this item