This is my baby Ryuu dragon.
Ryuu means dragon spirit.
in the 3mf we have 2 plates.
a small version at 110%, you can go to 100% but be carful with the wings.
and a large version which is a full build plate.
WARNING the wings are print in place ball joint, if printing small they can be delicate. gently move the ball joint to release the fixing. the fixing is in place to stop the ball moving during printing. once release the wing should fully rotate.
the wings require a small support at the base. to help with adhesion in the early stages. be careful removing these supports after printing. the supports are included in the 3mf but make sure they are normal support and not tree. they do not actually support any over hangs but just stop the wings coming loose. if in doubt use a little glue in this area. please don't rate using bed adhesion issue if you haven't used supports. as described.
if printing the large version you may want to remove the purge line at the front of the plate at the start of the print.
there are included purge objects on the build plate to help reduce waste, just delete these objects if not required.
you can print at 0.16 layer also