tracking pixel
David F

Engineer's Desk Organizer

by

DrDflo

Follow
Follow
Remix Model
Like
DrDflo
DrDflo
Image 1 of 5
Desk Organizer in use! This is the accent version with the Mag Safe charger for iPhone.
Engineer's Desk Organizer - Desk Organizer in use! This is the accent version with the Mag Safe charger for iPhone. - 3d model
2D
3D
Makes
Engineer's Desk Organizer - Desk Organizer in use! This is the accent version with the Mag Safe charger for iPhone. - 3d model
Engineer's Desk Organizer 3d model
Engineer's Desk Organizer - I will gladly post this remix when it is done  - 3d model
Engineer's Desk Organizer - Hers my make as promised! - 3d model
Engineer's Desk Organizer - Before filling.  - 3d model
This model is restricted by licensing terms. 
642 Likes1.9K DownloadsNovember 20, 2021
This model is restricted by licensing terms. 


A 3D Printable organizer for your desk or workbench. Store your calipers, tape measurer, flash drives, SD cards (both full size and micro), and your writing utensils. A phone stand is integrated into the organizer, which is compatible with Mag Safe for wireless charging. Underneath the phone stand are three drawers for storing cables or small parts that would otherwise get lost.

There are a couple different versions of this model. You can choose to have the cutout for the Mag Safe, but Android users may prefer to go without this feature. The other option is to print the organizer with accents or without.

If you choose the model with the accents, then please note this model was NOT designed to be printed with dual extrusion. The accents need to be attached with super glue or a similar adhesive. The reasoning for this is because most people do not have access to dual extrusion or a printer with two extruders that can print a 120 mm x 235 mm x 120 mm (LxWxH) part. Examine the accents before gluing them down. The accent on the left side should match the radius on the back of the organizer and come to a point a with the accent that runs along the front.

My favorite filament for printing this model:

Print Settings 0.4mm Nozzle 0.2mm Layer Height Support: Print Support for overhangs less than 55 degrees.

Socials: Youtube Instagram

Please note that affiliate links are present to support the creation of these models.


642 Likes1.9K DownloadsNovember 20, 2021




This model is restricted by licensing terms. 
642 Likes1.9K DownloadsNovember 20, 2021
This model is restricted by licensing terms.