Phone Stand Print-In-Place (v1.5)

!!! Make sure you don't experience stringing !!! !!! Print-In-Place !!! Normal Version: https://thangs.com/VeYlon/Phone%20Stand-51472?manualModelView=true

UPDATE 2

• Added the Normal Version with a screw-on cap (linked above)

UPDATE 1

• The Overhang where the two parts join might be difficult to remove - I used a Hammer to separate the parts and get them moving
• a Knife/Scapel could also work alltough it might need some force depending on the bridging capabilities of your printer (Thanks to jimmypuurple)

(Around 0.3-0.4mm tolerance except the Overhang mentioned above which is 0.2-0.28 depending on your Layerheight)