Introducing the Agony Axe used by Spawn! It is print in place with minimal supports. This was made with a 1/2 inch diameter PVC cavity in the handle for support. You will need to use supports for the head, pommel, and handle parts. The axe and handle parts you may need to use a brim for better stability while printing.

You will need to print x1 of everything except the following: Key Joint x6 Axe Top x2 Axe Bot x2

For assembly PVC should be cut to about 24 inches (609.6 mm). Glue the two parts of each axe top and bottom together using the key joints to have two whole assembled axes. You can put in the PVC core as you assemble the pommel, handle, and head of the axe then attach the assembled axes on either side.