For Snapmaker 2 Enclosure: Webcam Mount BASE (remix) for TeachingTech's flexible camera mount

Model originally uploaded to Thingiverse at https://www.thingiverse.com/thing:4716778.

This is for a neat little webcam that's only $4.95 on Amazon, with free shipping! It's compatible with Octoprint / Octolapse right out of the box.

TeachingTech provides various choices of camera mount BASES for his "Flexible webcam mount for Octolapse." Some of the mount bases are for specific 3D printers (one is a Prusa i3). One is a generic mount base. The difference on these is not the tops. It's the bottoms — various clips or screw hole patterns, etc. And he made the geometry available so remixes could be done.

This is a remix mount base that is meant for use in Snapmaker 2 enclosures. It lets TeachingTech's flexible camera mount be attached to the rails (either upper or lower, by use of two different choices I provide). I've topped off on the business end with an extremely affordable, off-name brand basic webcam, that I bought on Amazon for $4.95 (with free shipping), and it just so happens to work "out of the box" with Octoprint / Octolapse.

Tools / hardware needed: none. It's a "snap in" base for the flexible webcam holder — either up above (upper rail looking down) or down below (lower rail, rising up to look across).

Be sure to check out my other thingyverse remix item for the other end of TeachingTech's "Flexible webcam mount for Octolapse," which is the mount tip, and lets you use the neat little webcam linked above. (There may be, likely are, other cheap webcams that have the same "swivel+fold" base and that that remix would fit.) NOTE: The mount tip's key "tube" area with the hole for the included brass fitting, is 20mm long.

https://youtu.be/0wTtTB5NTKc

Note: all Amazon urls are affiliate links.