tracking pixel
DaveMakesStuff

Schwarz D Egg

by
DaveMakesStuff
Follow
Follow
Remix Model
DaveMakesStuff
DaveMakesStuff
|
Image 1 of 2
Schwarz D Egg 3d model
DaveMakesStuff
DaveMakesStuff
|
Image 1 of 2
Schwarz D Egg 3d model
2D
3D
Makes
Schwarz D Egg 3d model
Schwarz D Egg 3d model
This model is restricted by licensing terms. 

This egg design is part of a series of “10 Decorative Minimal Surface Eggs”. The series was originally created in 2021. See my page for a more recent similar series of hollow “10 Easter Eggshells” that can be used to store objects or candy. The descriptions below offer specific suggestions for printing. One general word of caution is when using “tree” supports, be sure to add “support blocks” to prevent the tree structures from extending up into the interior of the egg. They’ll be impossible to remove. Expect to do a bit of post-print cleaning with each piece. Schwarz' P Egg This relatively simple egg requires a small amount of tree support to the bottom bulge. This is a good one to start with. Schwarz’ D Egg The Schwarz D Egg has some overhangs that may not be properly supported by standard supports. The piece is provided plain and with custom supports. Schoen’s Gyroid Egg The Schoen’s Gyroid Egg requires tree supports for the bottom third or so. Schoen's Batwing Egg The Schoen's Batwing Egg is tricky in that it has some rather large horizontal surfaces. The model shown was printed with an extensive amount of tree support. While the overall structure held up, the undersides of the horizontal surface required a lot of cleanup. Fischer-Koch S Egg The Fischer-Koch S Egg has some overhangs that may not be properly supported by standard supports. The piece is provided plain and with custom supports. Schwarz’ CLP Egg This relatively simple egg requires a small amount of tree support to the bottom bulge. This is a good one to start with. Schoen’s I-WP Egg Schoen’s I-WP Egg requires tree supports for the bottom third or so. Schoen’s F-RD Egg Schoen’s F-RD Egg has some overhangs that may not be properly supported by standard supports. The piece is provided plain and with custom supports. Schoen’s F-RD(r) Egg Schoen’s F-RD(r) Egg requires tree supports for the bottom third or so. Fischer-Koch C(Y) Egg Fischer-Koch C(Y) Egg has some overhangs that may not be properly supported by standard supports. The piece is provided plain and with custom supports.


27 Likes119 DownloadsApril 12, 2022



27 Likes119 DownloadsApril 12, 2022
This model is restricted by licensing terms.