Drink holder + phone stand + remote holder for any large/wide sectional or couch armrest or back of the couch.

A plug STL file is now included in the additional files that fits the medium and large Couch Caddy to help any cups that may sit funny or wobble in the cupholder.

The non-remote side is easily narrow enough to go between your sofa and the wall). This will fit armrests between 165 - 178 mm. The opening for this new release is 178 mm.

You can find the large 230 mm model on my profile.

It holds drinks (including mugs w/ handles, soda cans, large drinks, Stanley Cups), your phone, and two remotes, and also has a small tray area for whatever else.

I printed with PLA, but PETG or similar may offered increased strength and water resistance.

Recommended Print Settings: 0.2mm layer height 3 walls 20% or more infill (higher infill will increase strength, but I have found not worth going higher than 25%) You shouldn't need supports, depending on your printer. The only supports you may want is for the remote holder (see version notes below). This is Version 1. If there is interest, I would make:

• multiple sizes one with a phone stand to fit phones vertically with large drinks (they get in the way a little).
• a drink holder plug to fill the smaller hole for better drink stability. adjusted angles to - - make “no-support” printing available to more printers slightly reinforced walls, multiple drink holders, or other features.