Planet, sun, comet, and solar eclipse ornaments.
Roughly 8.2 cm across (to widest points).
2 mm thick.
3 mm hole on top for hanger/paperclip etc.



Space Ornaments

Comet Ornament.stl

Cougar, wolf, elk, and moose ornaments.
8.2 cm diameter.
2 mm thick.
3 mm hole on top for hanger/paperclip etc.

Wildlife Ornaments

Cougar Ornament.stl

Rectangular contain. Inner dimensions are 3.625" by 1.25" by 5.125" high. Designed to fit postcards. Added a 1/32" interference for the lid to make it hard to pull off, can scale it up/down if it doesnt fit good.

Cougar Rectangle Container

Cougar Rectangle Container (Display Only).stl

60mm inner diameter inner space.
Roughly 68mm high inner space.
Will need supports for the top part.
Got the apple model from here : https://www.thingiverse.com/thing:4678694

Apple Container

Apple Container (Display Only).stl

8cm Diameter.
2mm thick.
3mm diameter hole on top to hang from paperclip/hook.

Snowflake and Tree Ornaments

Snowflake and Tree Ornament.stl

Circular Container.
90mm inner diameter.
92.5 inner height.
Added 1mm diameter clearance between lid and container.



Cougar Circular Container

Cougar Circular Container (Display Only).stl

Circular Container.
90mm inner diameter.
92.5 inner height.
Added 1mm diameter clearance between lid and container.

Wolf Circular Container

Wolf Circular Container (Display Only).stl

Fits iPhone 8.
Thicker extrusion widths may not show up in some places on the first layer in your slicer program, but it should print out fine.

Wolf iPhone 8 Case.stl

Fits iPhone 8 Plus.
Thicker extrusion widths may not show up in some places on the first layer in your slicer program, but it should print out fine.

Wolf iPhone 8 Plus Case.stl

Cougar iPhone 8 Case.stl

Fits iPhone 8 Plus. 
Thicker extrusion widths may not show up in some places on the first layer in your slicer program, but it should print out fine.

Cougar iPhone 8 Plus Case.stl

Stackable filament holders. Designed for 2.75" wide spools with 8" outer diameter. Rod #1 can hold 1 spool and Rod #2 2 spools.

-Support #1 : 7.25" x 4" , support rod 5.75" high.
-Support #2 : 7.75" x 3.185" , support rod 14.25" off ground.
-Rod # 1 : 3.875" long , 0.5" diameter.
-Rod # 2 : 6.625" long , 0.5" diameter.

Double Stack Filament Supports

Filament Supports (Display Only).stl

Filament spool support. Fits Ender 3 Pro, sits at ground level to left of printer (support rod facing away from front).
5.75" height to center of holding rod. Holding rod is 1" across. Base is 4" wide.

filament support.stl

Activity related to collaborating with others on models

Likes, comments, and activity from your community

A roundup of models that we think you'll like

DERZ13