Hey everyone! I'm going to start doing first release models of some things to my subscribers! This is the first one. It's hard to find a good universal bookmark, so this is the first in my small series of infill bookmarks!
1)Top & Bottom Layers- set both of these to "0", this will ensure that you can see your infill pattern in the middle of the bookmark this is the most important step 2)Walls- I would use anywhere from 8-10 this will give a nice rigid border for the infill, but you could go even higher if you like. 3)Select your infill pattern- note what the infill looks like when you slice it (octogram spiral will not work with the rectangle bookmark due to how it comes together in the center, working on that). You want at least a 20% infill for most of the patterns, but i would recommend a start of 25%.