Awarded to:BrandonmPatrick

First Make published

May 25, 2024 · 4:11 AM

BrandonmPatrick

0

Followers

1

Following

0

Model Views

0

Downloads

0

Comments

0

Likes

Achievements

Novice Maker

First Make published

0

Followers

1

Following

0

Model Views

0

Downloads

0

Comments

0

Likes

Sort by:

BrandonmPatrick

Aloe Vera Pen Plant - Printed with Hatchbox white pla and Eryone olive green pla. Opted to paint the spots on later tos ave filament. I didn’t have any red clay-like filament so I made my own white geometric planter that I scaled to fit the insert in blender.
Tips: Hit the stem holes with a heat gun on low for maybe 10 secs each to make it easier to get the pens down in them.
Bore out the caps with a small rasp/file or exactly knife for a better fit. I’ve still got a few to fine tune.
Once you get magnets in the base, give each installed magnet a pair and mark the outward face with a sharpie so you don’t install it wrong into the stem.
Use a flat surface on a pair of pliers to persuade the magnets into the holes easier.
If you dial in your printer this all fits together very well! I printed mine across an A1, an A1 Mini and a K1 Max and everything is fairly snug and lines up well. Great design! Kudos Forge! Thanks for sharing. - 3d model