Print your floppy four leaf clover today! It's almost clovering time! (Is that a word?)

Printing Instructions: The 3mf file was saved using Bambu Studio and should already have the following settings configured:

Layer Height: 0.16mm Wall Loops: 3 Supports: Nope!

Make sure you have your build plate nice and clean to avoid adhesion issues. Either clean it with an ammonia based cleaner like Windex or clean it with high quality dish soap and warm water. IPA also works, but not guaranteed to work.

Thank you for your time and consideration on this matter.

Feel free to join my discord for additional support, questions, or suggestions!