LED Fairy Light Diffuser - Spiral

I have a lot of LED lights that I put up at Christmas but they're so bright, it can be quite distracting and uncomfortable to look at so I made these caps that diffuse the light and make them look a little more like traditional fairy light bulbs too.

They friction fit perfectly on the two sets of lights I tried them on but they'll scale up or down just fine if need be.

I printed mine in clear PETG as they were going on coloured lights but they could also be a great way to convert white bulbs to coloured lights if you printed in coloured filament instead.

These are intended to be printed in vase mode so the model is solid - you need to enable vase (spiralise) mode and set bottom layers to 0