Reloading funnel for 5.56x45 / .223 Remington. Git er' done. 

5.56x45 Funnel.stl

Just a simple tray for reloading 5.56x45 or 300 Blackout; cases fit... "Real Nice, Clark". Can't stand how some cases flop around in the universal trays. 

 5.56 & 300 BLK Tray.stl

Powder funnel for .308 Win. Git er' done. 

308 Winchester Funnel.stl

308 Funnel.stl

Powder funnel for .300 AAC BLK... git er' done. 

300 BLK Funnel.stl

300 BO Funnel.stl

3D Fuel Pro PLA+, 100% fill. 
Supports printed everywhere (Cura, 45 deg overhang) 

Slice and print parts in the orientation provided; this maximizes part strength on the axis that matter.
Additional parts needed: (2) 4-40 x .375" button head screws, trim one to .300".  (1) Alien Gear retention nub; this must be scavaged from an existing retension block. 
Also need a 4-40 tap. 

Disclaimer: I have no idea if this will work with other Shapeshift holsters; I've only got the one for the P365 XL Romeo Zero. Godspeed. 

Alien Gear Shapeshift Claw - Sig P365 XL

Shapeshift Claw_RevD.stl

I wanted a way to mount my iPhone 11 Pro Max (& case) to my Evolution Edge HD telescope; prefer to drive it that way. Also wanted to retain the Starsense keypad, as it's the best way to drive the focus motor accessory and make minor aiming adjustments. 

The phone case is a Nomad, but other cases are similar size. If your phone is no more than 82mm wide x 14mm thick, it should fit. I also included a charger hole. 

I printed this on my Ender 3 Pro, using 3D Fuel Pro PLA in midnight black. 

Additional stuff you'll need:
-VHB tape for the hand controller ring; I prefer 3M's RP family of tapes (RP45, 32, 16 mil, etc.)
-Two 10-32x1.5" Thumb screws, such as McMaster-Carr part number 91185A390
-Two 10-32 square nuts, such as McMaster-Carr part number 94855A283

Enjoy!

Celestron Evolution Phone Bracket & Hanger.stl

I wanted a way to mount my iPhone 11 Pro Max (& case) to my Evolution Edge HD telescope; prefer to drive it that way. Also wanted to retain the Starsense keypad, as it's the best way to drive the focus motor accessory and make minor aiming adjustments. 

The phone case is a Nomad, but other cases are similar size. If your phone is no more than 82mm wide x 14mm thick, it should fit. I also included a charger hole. 

I printed this on my Ender 3 Pro, using 3D Fuel Pro PLA in midnight black. 

Ditch that 30 round spacer and go for 50. 

PS90 Mag Floor Plate.stl

A cap for 7/8-14 threaded dies; save that decapping pin!

Reloading Die Cap v3.stl

Handy wrench for the Lee 4-Station Turret Press. 

LEE Wrench.stl

Activity related to collaborating with others on models

Likes, comments, and activity from your community

A roundup of models that we think you'll like

AmateurHour