This model is restricted by licensing terms.
View license.
205 Likes1K DownloadsJune 30, 2022
This model is restricted by licensing terms.
View license.
Have fun with this little wave toy. See it in action here: https://vimeo.com/725552445
It prints in place, without supports. When you have finished the print take the base off first and push onto the main model, this will give you a bit of stability before removing it from the bed.
Make sure you can see the strings down the centre in your print preview.
I recommend a layer height of approx. 0.3mm
Categories:
205 Likes1K DownloadsJune 30, 2022
This model is restricted by licensing terms.
View license.
205 Likes1K DownloadsJune 30, 2022
This model is restricted by licensing terms.
View license.