Giant Snowman - Plain Head

Plain Head for Giant Snowman Fidget.

Download the base model here

https://youtu.be/QvqppWoIySs

https://youtu.be/S00Uxp5Etow

Printing

• All parts can be printed without supports.

Assembly

• Cut a length of TPU that is at least 150cm.
• Fold the TPU in half and tie a knot 50cm down from the fold. This will create a 100cm loop with two loose ends that are 25cm each.
• Thread the TPU loop through the snowman head.
• Pull both ends of the TPU through the scarf, middle section.
• Pull the looped end of the TPU through one of the holes in the snowman base. Secure it with a tension cap.
• Pull the other end of the TPU through the opposite hole in the snowman base. Pull the TPU tight until the knot comes through the hole. Secure this end of the TPU with another tension cap.
• Push remaining TPU into the snowman base where it can be pulled out later for disassembly.

Can I sell copies of this?

Yes! This project was shared under the Creative Commons - Attribution license.

This license allows selling copies, but you must provide proper attribution, as detailed in the license itself.

Please note that any other projects linked here (remixes or related projects) may have a different license. Please respect those licenses.

This license applies only to the model files (STL, 3MF, STEP, F3D) included in this project. It does not apply to photos, videos, my logo, or other supplemental graphics attached to or displayed with this project.