A rail that clips on to the Keychron K# series of keyboards' aluminium rails.
Supports are recommended, remove them carefully to make sure you don't damage the stabilising part of the clip.

Keychron k series aliminium rail adapter

Friction-fit thin shell case for the bottom half of the Jlab Go Air Pop. The belt clip is detachable and held in place with a dovetail slider for the possibility of other attachments in the future.

JLab Go Air Pop case with detachable belt clip

Jlab Case and Belt Clip.stl

**For best result make sure the face where you insert the charger is the one touching the bed.**

Companion to my other Sexy hexy magsafe stand, but with a rear cable exit.

I've included spots to add rubber feet to the bottom, but you can also tape it down for a more permanent solution. To add the decorative elements just use a bit of CA glue.

Materials: eSun PLA+ in black, eSun Matte PLA in mint green
Settings:
Infill - 10%
Supports - yes
Layer height - 0.15mm or 0.3mm if you want it done quicker

Sexy hexy magsafe stand - rear cable exit

magsafe stand rear cable exit.stl

**For best result make sure the face where you insert the charger is the one touching the bed.**

I needed a magsafe stand where the wire came out the front which is surprisingly hard to find.

I've included spots to add rubber feet to the bottom, but you can also tape it down for a more permanent solution. To add the decorative elements just use a bit of CA glue.

Materials: eSun PLA+ in black, eSun Matte PLA in mint green
Settings:
Infill - 10%
Supports - yes
Layer height - 0.15mm or 0.3mm if you want it done quicker


Sexy hexy magsafe stand

Charging stand main.stl

It's a gridfinity phone stand with a cutout for a magsafe popwallet+ I don't know what more explanation you need.
Accommodates medium thickness phone cases (I use a dbrand grip case and it fits in perfectly)

Gridfinity phone stand with magsafe popwallet+ cutout

Raises the Megalodon KB16 to match the 9° incline option of most keyboards.
**Update:** Fit issues fixed. Added 11mm holes on the underside for sticking on rubber feet to stop it sliding around your desk.

9° DOIO Megalodon KB16 stand

Raises the Megalodon KB16 to match the 9° incline option of most keyboards.
**Note:** Fit might be a bit snug if you are using a filament with a high shrinkage rate. I would recommend printing at 100.5-101% if this is the case or you can sand or file down the internal sides a little bit.

Raises the Megalodon KB04 to match the 6° incline option of most keyboards.
**Note:** Fit might be a bit snug if you are using a filament with a high shrinkage rate. I would recommend printing at 100.5-101% if this is the case or you can sand or file down the internal sides a little bit.

6° stand for DOIO Megalodon KB04

I just like making things to make my life easier.

Activity related to collaborating with others on models

Likes, comments, and activity from your community

A roundup of models that we think you'll like

For when we think someone might have posted your content as their own

New content from your premium memberships

Emails and messages from designers you follow

-el-gato