This Minecraft Chestplate is printed with following order of filament colors :

1. Elegoo PLA Sparkle Green
2. Elegoo PLA Sparkle Turquoise
3. Sunlu High Speed PLA Mint Green
4. Sunlu High Speed PLA Ice Blue
5. Elegoo PLA White

Each armor pieces requires TWO 12x3 magnets.

The following print settings are a must:

• 0.2mm layer height (necessary for the pauses)
• 2 shells/perimeters (can be increased if you want to use more filament)
• 4 top surfaces
• 15% infill
• slow down top layer to around 60-80mm/s
• 15mm Mickey Mouse Ear brim attached at 0mm if you're uncertain about your bed adhesion at the corners
• Colors & Pauses: Start printing with Elegoo Sparkle Green Layer 19 (3.8mm) - Insert magnets with a drop of glue to prevent them sticking to nozzle Layer 57 (11.4mm) - switch to Elegoo Sparkle Turquoise Layer 61 (12.2mm) - switch to Sunlu Mint Green Layer 65 (13mm) - switch to Sunlu Ice Blue Layer 69 (13.8mm) - switch to Elegoo White